Knowledgebase

Preparing the ground for raised beds #906578

Asked June 20, 2025, 2:10 PM EDT

My husband and I are getting ready to prepare space on which to place raised beds. We are having trouble deciding how to go about preparing the ground. Currently, there is grass/sod and weeds in the spot. I have read that you can put cardboard on the space to kill the grass but we don't love that option because of how it will look to have cardboard on our lawn. We have discussed using a tiller to till the ground, including the grass, but my concern is that kicking up weed seeds and/or not fully killing the grass. Just wondering what the evidence is about the best method to clear a space that will be both aesthetically pleasing but also good for the future soil of the plants.

Franklin County Ohio

Expert Response

How deep will the beds be that you are putting in?  It sounds as if you will be prepping ground soon and not putting the beds in until later? The cardboard often used to block weed/grass growth would be invisible as soon as the beds and soil were in place.

Will these be ornamental beds or vegetable gardens?  You would probably not want to use chemicals for vegetable gardens, as there is some question as to residue in the soil.

I assume these are open bottom beds. I have used the cardboard/mulch for a season to kill grass & weeds before planting both vegetables and native plants, but my beds were not in my front yard so I wasn't worried about what they looked like.  There are certainly other options, and I can filter my research a bit if I know more about your plans.
Jena,
Without knowing any of the details about your raised bed project, I am copying part of a paper I researched for a class on preparing soil for a new planting of native plants. The options are similar for your future raised beds if you want to eliminate the grass/weeds ahead of time.  If you are putting the beds in soon, you could follow the sheet mulching instructions below and place the beds over it right away, covered with the soil you plan to use.  (Note that raised bed fill is different from plain garden soil--more drainage is generally needed.)  That way no one would see the cardboard. If there will be a delay in placing the beds, the cardboard covered with mulch probably wouldn't look bad--a little odd, but not bad. The mulch should be removed before you place the soil you will plant in.

The following are common options in ground prep for a new garden site:

  1. “Sheet mulching” covers the planting area to suffocate current vegetation. Mow short, cover with cardboard (overlapping, not shiny or including tape/staples), water thoroughly, and cover with arborist wood chips 4-6” deep. Pull mulch back for transplants. If planning to plant seed, you may need to wait an entire season and use aged wood chips. Otherwise plan to weed around your transplants. (Worms love this method.
  2. Solarization—heat an area using clear plastic and burn out existing veg. Works best in hot summer, heavier plastic, dig ends in well to avoid air entering the space. Mow short to start. Will kill some other soil life with the heat. This will take a minimum of 4-8 weeks.
  3. Black plastic tarp, weighted down to prevent light, air getting in; plan to leave down for at least 4-8 weeks. Earthworms prefer this method, or the smothering with cardboard above. This is called occultation.
  4. Repeated cultivation for a minimum of three cycles to kill newly sprouted weeds. You could till first, then do very shallow weeding or flaming each time weeds hit the white thread stage. Do not till deeply, or new weed seeds will be brought up. You could follow this with cover cropping if you have time. Choose a cover crop that will grow densely enough to crowd out weeds. Buckwheat is a good warm-weather choice.
  5. If you have a lot of energy, get out your shovel. You can dig up all the grass in chunks, turn it upside down, then cover it with soil and mulch. This may create a DIFFERENT weed bank, and you will still have to weed, but it is quick and can be used in the spring that you want to plant.
  6. Use of broad spectrum herbicide (FOLLOW LABEL DIRECTIONS) multiple times. This requires a whole growing season. 3-4 applications, followed by waiting 2 weeks for die off, mowing low, bagging clippings. Late April/early May, late June/early July, late August, early October if needed. Seed in late fall. This is probably the best method (other than the use of the herbicide) for large areas that will be seeded.
I hope this information is helpful to you; if you have other concerns or questions, please reply to this post.  Thank you for asking extension about your new raised beds. 



Loading ...