Knowledgebase

lowering pH around existing blueberry plants #853068

Asked October 13, 2023, 4:42 PM EDT

I planted several blueberry plants last spring before I realised that its best to lower pH 6-12 mos. BEFORE planting. the pH is 6.5. A couple months after planting, the leaves were rapidly turning red so, in desperation, I tried adding fertilizer around each plant. (1/2 Osmocote 10-10-10, the other 1/2 Epoma organic fertilizer). To my surprise, all the plants recovered, and the red disappeared! The new growth is a bit "leggy" (due perhaps to too much nitrogen) but the plants are healthy and robust. But now I want to try lowering the pH. I have several questions so I'll number the to avoid confustion: 1) How should I apply elemental sulfer (and/or ferrous sulfate) to the bed? Between the plants and around the dripline of each plant? Or? 2) How much should I add? (I've seen the chart for lowering pH before planting) 3) How deeply can I stir it into the soil without damaging the roots of existing plants? 4) Do blueberry roots extend past the dripline? Or not? and finally... 5) Why would adding fertilizer revive plants that were suffering due to excessively high pH? Did the extra nutrients somehow compensate for the difficulty of the plants in 6.5 ph soil to uptake nutrients? Thank you! Tom Smerling Takoma Park, MD Thank you!

Montgomery County Maryland

Expert Response

Hi- blueberry plants can be a bit temperamental in getting established. Yellow, red, and purple leaf color is a sign of stress, especially in young plants, that can be caused by one or more factors (excessive heat, insufficient water or nutrients, high pH and low organic matter, root restriction).

Blueberry plants lack root hairs so are easily water-stressed. Keeping the root zone uniformly moist is essential. You can achieve this with high soil organic matter content (>8% as measured by soil testing labs; this is done on a weight basis, not a volume basis), thick organic mulch, supplemental watering when rainfall is lacking (drip irrigation and soaker hoses can be very useful).

1. Pull back any mulch and broadcast the sulfur as evenly as possible across the entire bed, around and between plants.
2. Apply 4 lbs. of elemental sulfur per 100 sq. ft.
https://hgic.clemson.edu/factsheet/changing-the-ph-of-your-soil/
3. Use a rake to lightly incorporate the sulfur into the top few inches of soil. Water it in and replace the mulch over top. 
4. Yes, but applying the sulfur to the bed is sufficient.
5. Plant-available nutrients from the fertilizer plus regular watering helped your plants. Blueberry growing in high organic matter soils with a 6.0-7.0 pH can grow ok, but lowering the soil pH is very beneficial for long-term health and productivity. 

Ammonium sulfate is an excellent synthetic N fertilizer for blueberry.
Jon

Loading ...